ADLINK ND-6056 DRIVER FOR WINDOWS 7
ADLINK ND-6056 Driver
Products - of - ND - ADLINK Technology Inc. # Channels: 15# Isolation Voltage: VRMS# Switching Level: with 24 V common power. ADLink, NuDAM driver: a) b) c) d) ND, ND, ND, ND, ND, ND, ND, ND, ND, ND, ND, ND Va oferim interfete si module de achizitie de date, sisteme modulabile de achizitie distribuita, solutii la cheie pentru automatizarea proceselor industriale.
|File Size:||14.9 MB|
|Supported systems:||ALL Windows 32x/64x|
|Price:||Free* (*Free Registration Required)|
ADLINK ND-6056 Driver
The case will not be open. The New Hardware Wizard appears, click on Next to continue. In the dialog box that comes up, leave the default choice Search for the best ADLINK ND-6056 for your deviceclick on Next to continue.
In the dialog box that comes up, leave the ADLINK ND-6056 choice Floppy disk drivesinsert the distribution diskette in the floppy A: In the dialog box that comes up, click on Next to continue. Files are now copied to your hard disk. After the driver files ADLINK ND-6056 been copied to the hard disk, a dialog box appears to tell you that the installation has finished.
What's missing? Tell us about it.
Click on Finish. Then there will be a dialog box as following 3. NuDAM 5. Then you should ADLINK ND-6056 the driver to find the following device 6.
Switching - All Manufacturers -
After this, you should see the dialog box as Then you have success to install the ND on your host 7. To check if the installation is success, please check the device in your device manager, and there should be a device as NuDAM? Stop bits: None, Even, Odd Data bits: Isolation Voltage: Power Consumption: Positive Temperature Coefficient 50? Backup your software diskette 3. Please follow the steps of setup program then you can successful to install the nudism Administration. Address ID is ADLINK ND-6056 Under this state, the default configuration is set as following: Baud rate is bps. Host computer with an RS port. Initialization Procedure 1. Power off the ADLINK ND-6056 computer and the installed NuDAM or Be sure of the baud rate of the NuDAM or is bps. Refer to Figure 5.
Nudam - ID:5c54abcb8
Power on the host computer. Power on the power supply for NuDAM modules. Installation Procedure 1. Configure the new NuDAM ADLINK ND-6056 according to the initialization procedure in section 2. The baud rate and check-sum status of the new module must be identity with the existing RS network.
广东深圳视频模块 ADLINK Technology电子全系列 界面模块 存储卡价格 - 中国供应商
Power ADLINK ND-6056 the host computer. Wire the power lines for the new NuDAM with the existing network. Be careful about the signal polarity as wiring. Wire to the input or output devices.
Refer to ADLINK ND-6056 2. Power on the NuDAM local power supply. Use the NuDAM administration utility to check entire network.
The host computer can only command only one NuDAM module. The slave device may or ADLINK ND-6056 not give response to the command.
Document Conventions The NuDAM command is composed by numbers of characteristics, ADLINK ND-6056 the leading code, address ID, the variables and a carriage return to indicate the end of a command. Variable length Some output command need data. Variable length Checksum in brackets indicate optional parameter, only checksum is enable then this field is required.